Press the diagnostic button once.ĭefault = what the unit thinks the salt level is due to an average of all previously recorded “instant salt readings†from all of the different polarity changes since the system was installed, or since the last time the unit was recalibrated.įirst the unit reads the temp, then the voltage in the cell, then the amperage, then it will display the desired output percentage (where you have the dial set to), then next reading is the “instant salt readingâ€, or what the cell thinks the salt level is right at that moment. Once this happens the cell has just engaged and is trying to measure the salt level. Once flow is established the unit should begin to display the “POWER†& “GENERATING†lights solid green. If the pump is not running, the system will show “NO FLOWâ€, if flashing this is just a warm up process and the unit is waiting for the water to begin moving through the cell to carry the chlorine out to the pool. When attempting to recalibrate the average salt reading (default reading ) the pump needs to be running. How do I recalibrate my Aqua Riteâ„¢ Chlorine Generator? This also removes all past salt averages that may be in memory. Average 3200 and instant 3400 which is more in line with my tests. To reset these light just push the black selector button in for 3 to 5 seconds and this will reset the trouble lights. I got low salt and check cell trouble lights come on a few times until the average salt reading was above 2700 ppm. The only thing I had to do after the reset is to run and monitor the panel for about an hour or so. Well I cleaned my filters today, checked my cell which was spotless and reset my panel using the below procedures from Hayward/Goldline. Since its install in January the average and the instant salt readings have been 3700 ppm and I know that this is incorrect.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |